Our wireless PIR camera detector is a battery powered PIR detector with a difference...... it includes an integrated camera for visual verification and due to its 2-way communication with the Bulldog Secure Alarm control panel, can be programmed and adjusted without the need to remove the sensor

Upon an intrusion event, or if requested by the homeowner, the camera captures and transmits a sequence of images to the alarm panel which are then sent to your monitoring account so you can see exactly what is happened within the area covered by the PIR.
The images can then be viewed on your smartphone app or on the website and are stored for future reference. The visual verification feature enables self-monitoring and also reduces the number of false alarms, increasing peace of mind for you and saving time you stress and worry should your alarm be activated.
Your pet up to 36kg won't trigger the PIR, provided they remain below 1.5m from the floor.
As with all Bulldog Secure Alarm devices, the PIR will be pre-configured to work with your alarm system, comes with our full support service and instructions.

Detectors per System
32	Programme up to 32 detectors into your Bulldog Secure Alarm
Installation Time
10 minutes	Screws and adhesive pads supplied
Wireless
Yes	Fully wireless
Size
72 x 35 x 32mm	Small and Discreet
Batteries
3 Volt	Our PIR comes pre-installed with a battery so is ready to use with no additional batteries required.
Coverage Area
12 metres	Typical coverage area

Passive Infra Red Detector with Camera

Qty

Write a review